Bogen UTI1 User Manual

Installation
Wall Mounting
Mounting to a plywood backboard or studs:
1. Hold the unit level against the surface to which it will be mounted.
2. Mark where the mounting screws should be positioned.
3. Set the unit aside and install the screws leaving about
1
/4
" of the screws sticking out of the surface.
4. Slip the unit over the screws and tighten them snugly.
6

Bogen UTI1 Specifications

Impedance and Levels

input impedance	600 ohms
bgm input impedance	20k ohms
output impedance	8 ohms

Power

dc output	1A @ 24V DC
voltage	120V AC
current	0.5A

Operating Environment

temperature range	0 to 104º F (-18 to 40º C)
humidity	0 to 85% non-precipitating

Weight and Dimensions

dimensions	12-[1]/4" W x 5-[1]/4" H x 2-[1]/2" D
product weight	5 lb.