ImportAppliances.com
THE EASIEST WAY TO SELF-IMPORT APPLIANCES DIRECT FROM EUROPE.
44
en Preparation using ground coee
The milk is dispensed into the cup or glass
rst. Then the coee is brewed and runs
into the cup or glass�
Press C again to stop the current step of
the process prematurely�
Milk froth or warm milk
■ Place a cup or glass underneath the
beverage outlet�
■ Turn the control ring and select
“Milkfroth” or “Warm milk”�
F
The settings can be changed as
described in the section “Drink
adjustment”�
■ Press C to start dispensing�
Milk froth or warm milk is dispensed from
the beverage outlet�
Press C again to prematurely halt the
dispensing process�
Preparation using
ground coee
F
When using ground coffee, the
setting for the strength of the coffee
and dispensing two cups at once is
not available�
Important: Remove cups or
glasses before opening the door
in case they fall�
The appliance must be ready for use�
■ Open the appliance door�
■ Remove the ground coee drawer.
The removable drawer must be dry�
■ Put in coee powder (maximum 2 level
measuring spoons); do not press rmly.
F
Caution!
Do not use whole beans or instant
coee.
■ Replace the ground coee drawer.
■ Close the appliance door�
F
If coffee is not dispensed within
90 seconds, the brewing chamber
empties automatically to avoid an
overflow� The appliance is then
rinsed�
■ Place a cup underneath the beverage
outlet�
■ Turn the control ring and select a coee
drink or a coee drink with milk.
The display shows the selected drink, a
measuring spoon and the preset values for
this drink�
F
The settings can be changed as
described in the section “Drink
adjustment”�
For coffee drinks with milk, please
observe the instructions in the
section “Preparation using milk”�
■ Press C to start dispensing�
The coee is brewed and then dispensed
into the cup. When selecting coee drinks
with milk, the milk is rst dispensed and
then the coee brewed.
F
For another drink with ground coffee,
repeat the procedure�
Dispensing hot water
B
Risk of burns!
The beverage outlet gets very hot�
After use, always let it cool down
before you touch it�
The appliance must be ready for use�
■ Remove the milk tube from the milk
container�
■ Remove any milk or coee residue from
the outlet�
■ Place a cup or glass underneath the
beverage outlet�
■ Turn the control ring and select
“Hotwater”�
F
The settings can be changed as
described in the section “Drink
adjustment”�
■ Press C to start dispensing�
■ The message appears “Milk hose
separated from milk container?”�
■ If still connected, remove the milk tube
and touch [ Yes ] on the display�
Hot water ows out of the beverage outlet.
Press C again to prematurely halt the
dispensing process�