-7-
Do not direct the laser beam at persons or animals
and do not stare into the laser beam yourself. This tool
produces laser class 2 laser radiation and complies
with 21 CFR 1040.10 and 1040.11 except for deviations
pursuant to Laser Notice No. 50, dated June 24, 2007.
Working safely with the measuring tool is possible only when the
operating and safety information are read completely and the
instructions contained therin are strictly followed. Never make
warning labels on the Measuring tool unrecognizable.
Never aim the beam at a workpiece with a reflective surface. Bright
shiny reflective sheet steel or similar reflective surfaces are not
recommended for laser use. Reflective surfaces could direct the beam
back towards the operator.
Take care to recognize the accuracy and range of the device.
Measurement may not be accurate if used beyond the rated range of the
device.
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous radiation
exposure.
Safety Rules
To Next Page
Loading...
Need help?
General
