-11-
Specifications
Model number GWG12V-20S
Battery 12V Max (Bosch series)
Max no load speed 16,000 RPM
Switch type Paddle
Max collet ⌀ 5/16” (8 mm)
Max grinding wheel ⌀ 2" (50 mm)
Spanner at on clamping nut 17 mm
Permitted ambient temperature during charging +32…+95°F (0…+35°C)
Permitted ambient temperature during operation +5…+122°F (-15…+50°C)
Permitted ambient temperature during storage -4…+122°F (-20…+50°C)
Functional Description
Automatic Restart Protection
Helps prevent accidental startups after power
has been interrupted, e.g. the battery was re-
moved or discharged, or the tool stops due to
overload while the switch was in the on posi-
tion. To resume operation, turn on/off switch to
the off position, then restart the tool.
Constant Response Circuity
Helps maintain near constant RPMs between
no-load and load conditions.
Overload Protection
Helps protect tool from excessive heat that may
damage the motor. If all the LED indicator lights
ash yellow and the tool stops or slows during
operation, allow motor to cool for 30 seconds
by running no-load. If the overload protection
stops the tool repeatedly, excessive force is
causing the tool to overload. Stop excessive
force and readjust work piece to reduce force
applied.
Intended Use
Use this right angle die grinder only as intended. Unintended use may result
in personal injury and property damage.
This tool is intended for light: grinding, sanding, wire brushing, polishing, and carving, applica-
tions on metal, wood, plastic, stone, ceramic, leather and other materials. To perform any applica-
tion, mandrel mountable accessories, or accessories having shank diameter measuring 1/4" must
be used. All accessories used with this tool may not have a working diameter larger than two (2)
inches. Each accessory used with this tool must be carefully selected for the application, and may
include engraving cutters, tungsten carbide cutters, aluminum carbide grinding stones, polishing
points, small wire brushes and other similar accessories.
GWG12V-20S Die Grinder OSI Final for Approval 20230627.indd 11GWG12V-20S Die Grinder OSI Final for Approval 20230627.indd 11 6/27/2023 10:52:41 AM6/27/2023 10:52:41 AM
To Next Page
Loading...
Need help?
General