Bosch Indego M+ 700 User Manual

30 | English
Main Menu Sub-menu 1 Sub-menu 2 Explanation
Garden Overview Displays the number of mapped gardens, their size, their wire ID
and the date of the last time the garden was cut.
Delete garden Delete one specific garden map or select to delete all maps at
once.
Name mower Change the name shown in the display. Only letters of the Latin al-
phabet are possible. The number of letters is limited. This function
is not available in every language.
In some languages (e.g. Czech or Polish) a name change doesn't
have any effect on display due to specific grammar requests.
Tools
Level check Information about the ground angle of the mower. If the mower is
in the docking station and the dot on the display is not within the
indicated circle, the docking station must be mounted at a new,
more level location.
Wire signal Detects the wire signal received from the perimeter wire, indicat-
ing its strength (for Service Agent).
The mower will not receive a wire signal while in the docking sta-
tion.
Troubleshooting
Online Support
http://www.bosch-indego.com
Problem Possible Cause Corrective Measure
The LED on the dock-
ing station flashes
The perimeter wire is interrupted, too long
or too short. Wire not connected and
mower not in the docking station.
Check that the perimeter wire is not interrupted and is
between 20 and 350 meters in length. Then switch
power supply off and then on again.
Follow instructions in Installation Guide to install the
mower.
Excessive vibrations/
noise
Blade bolt loose Tighten blade bolt to torque of 2.5Nm.
Cutting blade damaged/bent
Replace cutting blade (see figure J).
Mower not docking
reliably
Perimeter wire not properly layed out
around docking station
Follow instructions in Installation Guide on layout of peri-
meter wire.
Perimeter wire close to a source of interfer-
ence
Remove any excess (e.g. coiled up) perimeter wire
around the docking station.
Change perimeter wire ID in the menu.
Mower fails to operate Isolator switch not turned on Remove mower out of docking station, turn isolator
switch on and place mower back into docking station (en-
sure docking station is on – LED lights up green).
F 016 L81 041 | (15.04.2020) Bosch Power Tools

Bosch Indego M+ 700 Specifications

General

Type	Robotic lawn mower
Motor type	Brushless
Cutting width	190 mm
Product color	Black, Green
Cutting system	Rotary blades
Maximum lawn area	700 m²
Maximum cutting height	50 mm
Minimum cutting height	30 mm
Suitable for slope up to	27 %
Number of height positions	3
Cutting clearance adjustment	Yes
Battery type	Built-in battery
Power source	Battery
Charging time	1 h
Battery voltage	18 V
Battery life (max)	75 min

Weight and Dimensions

Weight	7100 g