-24-
Operating Instructions
Side Switch (Fig. 20)
Never leave the trigger
locked “ON”. Before
plugging the tool in, check that the trigger
lock is “OFF”. Accidental start-ups could
cause injury.
Be aware of the loca-
tion and setting of the
switch “Lock-ON” button. If the switch is
locked “ON” during the use, be ready for
emergency situations to switch it “OFF”.
Do not use the switch
“Lock-ON” feature in
situations where kickback is likely, such
as when working into a corner. When the
wheel binds, the tool will kick-back in op-
posite direction of wheel rotation and the
release of the trigger “Lock-ON” may be
difficult.
TO TURN TOOL ON, press the back of the
switch and slide it forward towards the
gear housing until it comes to a stop and
the motor starts running. For Lock-ON,
when the switch is in the ON position,
press the front of the switch and release
it. the switch should remain in the Lock-
ON position and the tool will continue to
run.
TO TURN TOOL “OFF”, press the rear por-
tion of the switch. The switch is spring
loaded and will return to the “OFF” posi-
tion automatically.
Side
Switch
Fig. 20
To Next Page
Loading...
Need help?
General
