11/2011
i
Make sure that your TASSIMO machine
has been set up for use as described in the
section titled “First use of your TASSIMO
machine” on page 5
To prepare your favorite beverage, proceed
as follows:
► Turn the TASSIMO machine on by
pressing the ON / OFF switch (1)
► Place a suitable cup on the stand (7)
according to the type of beverage
Adjust the height of the cup stand, if
necessary, or remove it altogether for
large cups or glasses
► Always set the cup stand as high as
possible
Open the brewing unit by lifting the
handle (4a) and then pushing the
brewing unit up
Select a T DISC beverage and insert
it into the T DISC holder (4b) with the
printed side down
Make sure that the ap of the T DISC is
located in the slot in the front
Close the brewing unit by rst bringing it
down and then pushing the handle (4a)
rmly to the machine
► When the T DISC has been detected,
the
/
LEDs light up
!
For optimum results, ll the tank
with cool, fresh, non-carbonated water
each day Do not use chemically
softened water
¡
– Do not use chemically softened
water!Doing so could cause excess
pressure and damage to T DISC,
which could re sult in injury if brewing
unit is opened before the Status
LED F (3c) has stopped blinking
– Always wait until the Status LED F
(3c) has stopped blinking before at-
tempting to open the brewing unit
To Next Page
Loading...
Need help?
General
