11/2011
The following table provides solutions for problems and glitches that may arise as you
use your TASSIMO machine If you do not nd a solution for your specic problem or the
problem persists after troubleshooting, please contact
i
If the piercing unit is missing, it may be purchased from TASSIMO or Bosch Customer
Service Department at 1-877-TDISCS1 or only in the USA on wwwtassimocom
Appliance not working;
no symbols light up
There is no power
supply
Check that the appliance is prop-
erly plugged into the power supply
Machine brews but no
drink dispensed
The water tank is not
correctly positioned
Make sure that the water tank is
positioned correctly
The water tank was
removed during the
brewing process or there
is air in the system
Start a cleaning cycle with the
Service T DISC
The oat in the water
tank is stuck
Clean the water tank and ensure
the oat can move
Drink size smaller than
usual
Not enough water in the
water tank
Fill the water tank after the drink
has nished dispensing and press
the Start / Stop button to nish the
drink
The appliance needs
descaling
Descale the appliance (for details
see “Descaling”)
More steam than usual The appliance needs
descaling
Descale the appliance (for details
see “Descaling”)
The appliance does not
recognize the inserted
T DISC and remains in
stand-by mode or the
Status LED
F lights up
red
No T DISC inserted Check if T DISC has been
inserted
The barcode could not
be detected
Clean the T DISC barcode reading
window and try again or smooth
out the barcode on the T DISC
with your thumb
Use another T DISC
If problems persist, contact the
TASSIMO Customer Service
The brewing system is
not properly closed
Clean the brewing system thor-
oughly, especially in the area of
the clamp
To Next Page
Loading...
Need help?
General
