operation en
31
12.4 Starting the programme
Note:If you want to change the time
until the programme ends, set the
"Ready in" time first.
▶ Press Start/Reload.
a The display shows either the pro-
gramme duration or the "Ready in"
time.
a After the programme has ended,
the display shows: "End".
12.5 Adding laundry
After the programme starts, you can
remove or add laundry at any time.
1. Press Start/Reload.
The cooling process starts auto-
matically after approx. 30 seconds
and cools down the laundry while
the drum is rotating. If you want to
avoid or cancel the cooling pro-
cess, open the door.
→"Display", Page20
2. Open the appliance door.
3. Add or remove laundry.
4. Close the appliance door.
5. Press Start/Reload.
12.6 Cancelling the pro-
gramme
1. Press Start/Reload.
The cooling process starts auto-
matically after approx. 30 seconds
and cools down the laundry while
the drum is rotating. If you want to
avoid or cancel the cooling pro-
cess, open the door.
→"Display", Page20
2. Open the appliance door.
3.
Remove the laundry →Page31.
12.7 Unloading the laundry
1. Open the appliance door.
2. Remove the laundry.
12.8 Switching off the appli-
ance
▶ Turn the programme selector to
Off.
12.9 Fluff filter
During drying, fluff from the laundry is
collected in the fluff filter. The fluff fil-
ter protects the appliance from fluff.
Cleaning the fluff filter
If the drying programme has finished
or the display shows a notification
while the appliance is in operation,
clean the fluff filter.
Note:If you do not clean the appli-
ance as described, the appliance's
functionality may be impaired.
Requirements
¡ The display shows the following
after drying: "End"
¡ or during operation: .
1. Open the door.
2. Remove the fluff from the door.