Bose ControlSpace SP-24 User Manual (English)

Other manuals for Bose ControlSpace SP-24

Installation And Operating Guide40 pages

Quick Start Guide2 pages

Questions and Answers:

A
Amy ChristianAug 6, 2025
How to fix distorted sound on Bose Recording Equipment?
- M
  mitchellstephanieAug 7, 2025
  To address distorted sound on your Bose Recording Equipment, try the following: * Check that the Input Clip indicators are not lit red. If an LED is red, adjust the Max Input Level setting and/or Input Gain to better match the source output level. * If Max Input Level is set to 18 dBu and clipping still occurs, reduce the source Output level by reducing Output Gain from the source or use an inline attenuator device (pad). * If the SP-24 sound processor isn't showing clipping, reduce the Output Gain. * Use the SP-24 Editor software for full control and visibility of Input and Output levels. Adjust for optimal gain staging using the meters. * Verify that the loudspeakers are not overdriven or damaged by the amplifier.
W
wdavisAug 11, 2025
How to troubleshoot no power on Bose Recording Equipment?
- S
  Steve ChanAug 12, 2025
  If your Bose Recording Equipment is experiencing power issues, try these steps: * Turn on the power. * Ensure the power cord is securely connected to both the unit and the power outlet. * Verify the power outlet and any power extension cords being used are functional. * Try connecting the SP-24 sound processor to a different power circuit.
J
James SolisAug 18, 2025
Why does my Bose Recording Equipment sound unnatural?
- D
  Daniel GarrettAug 18, 2025
  If your Bose Recording Equipment sounds unnatural, consider these possible solutions: * Verify that the correct Bose® loudspeaker EQ is selected. * Check that Output connections are wired to the correct loudspeaker channel as selected in a Preset or Custom Scene. * In the SP-24 Editor software, check the Limiter settings. * In the SP-24 Editor software, ensure the output polarity controls (Output Gain block) are set the same for loudspeakers within the same system. * Verify the polarity of the signal chain is correct, including input cabling, output cabling, and amplifier output channels to the loudspeaker.
Y
Yvonne GarciaAug 25, 2025
What to do if Bose Recording Equipment has poor signal to noise performance (hiss)?
- D
  Daniel JohnstonAug 25, 2025
  To improve the signal-to-noise performance (hiss) of your Bose Recording Equipment: * Set the Max Input Level parameter to 18 dBu and ensure the source device level is ideally delivering a nominal 0 dBu signal. * Adjust the Input Gain parameter for each input channel so that the Max Input Level is just under the clip level. * Using the SP-24 Editor software, adjust the Limiter and Output Gain blocks for optimal output levels to match the input signal capabilities of the connected amplifier or powered loudspeaker.

Bose ControlSpace SP-24 Specifications

General

Input Channels	2
Output Channels	4
Frequency Response	20 Hz - 20 kHz
Input Impedance	10 kOhms
Output Impedance	100 Ohms
Crossover	Yes
EQ	Yes
Delay	Yes
Limiter	Yes
Mounting	Rackmount
Rack Spaces	1U
Power Supply	100-240V AC, 50/60Hz
Inputs	Analog
Input Connections	XLR
Outputs	Analog
Output Connections	XLR
Control	RS-232
Processing	Delay
Dynamic Range	110 dB
THD+N	< 0.01%
Total Harmonic Distortion	< 0.01%
Signal-to-Noise Ratio	110 dB