S
YSTEM SETUP
English Deutsch FrançaisDansk Español Italiano SvenskaNederlandsDansk Italiano SvenskaDeutsch NederlandsEnglish FrançaisEspañol
Setting up the L1
TM
model II power stand
1. Holding the power stand vertically on the foor (Figure 4A), grasp one leg and swing it out
as far as it will go. Notice that the other legs swing out automatically. The le
gs must be
fu
lly open before you can plug the L1
TM
bottom section into the power stand.
2. Lay the power stand flat on the floor in the desired position (Figure 4B).
Figure 4
Putting the power stand on
the floor
WARNING: DO NOT move the completely assembled system as a unit. This could result in
personal injury and/or damage to the product. Position the power stand on the floor in the
chosen location before assembling the system.
Assembling the L1 model II Cylindrical Radiator
®
loudspeaker
This procedure tells you how to set up the loudspeaker sections in the power stand. If you
plan to mount the T1 ToneMatch
TM
audio engine on the L1 model II system, see “Adding a T1
Tone M atc h
TM
audio engine (optional)” on page 12 before installing the top section of the loud-
speaker.
1. Hold the L1 bottom so that the grille faces fr
ont and plug it into the power stand (Figure
5A). Be sure to fully insert it into the socket
to assure stability and a good connection.
2. Align the bayonet on the L1 top with the channel on the back of the L1 bottom, and lower
th
e L1 top onto the L1 bottom until it is flush (Figure 5B).
Figure 5
Setting up the L1 model II
Cylindrical Radiator
®
loud-
speaker top and bottom
A
B
Socket for
L1 bottom
L1 top
L1 bottom
Bayonet
Channel
A
B
Front of
system
VeniceOG.book Page 9 Tuesday, January 16, 2007 1:28 PM
To Next Page
Loading...
Need help?
General
Weight and Dimensions
