Bose L1 Model II Manual

S
YSTEM SETUP
EnglishDeutschFrançais DanskEspañolItalianoSvenska Nederlands DanskItalianoSvenska DeutschNederlands EnglishFrançais Español
Connecting to AC power
1. Make sure the power switch is off.
2. Plug one end of the AC power cord into the AC Mains c
onnector on the power stand.
3. Plug the other end into a live AC (mains) receptacle (Figure 6).
Figure 6
Power connections
CAUTION: Bose recommends using a quality surge suppressor on all electronic equipment.
Voltage variations and spikes can damage
electronic components in any system. A quality
suppressor, which can eliminate the vast majority of failures attributed to surges, may be pur-
chased at electronics stores.
AC Mains
CAUTION: DO NOT block or cover
the handle opening, which is part of
the ventilation system. Doing so can
cause the L1
TM
model II system to
overheat, switch to a thermal protec-
tion mode, and temporarily turn off.
Power switch
VeniceOG.book Page 10 Tuesday, January 16, 2007 1:28 PM

Bose L1 Model II Specifications

General

Product color	Black
Bass adjustment	Yes
Recommended usage	Studio
Multi-Room Streaming (MRS) support	No
Speaker type	-
Number of drivers	2
Speaker placement	Stand-mountable
Audio output channels	- channels
RMS rated power	- W
USB 2.0 ports quantity	1
Connectivity technology	Wired
Power source type	AC

Weight and Dimensions

Depth	450 mm
Width	260 mm
Height	381 mm
Weight	11380 g