Bose L1 Model II Manual

English Deutsch FrançaisDansk Español Italiano SvenskaNederlandsDansk Italiano SvenskaDeutsch NederlandsEnglish FrançaisEspañol
OPERATING INFORMATION
Setting the analog input level
When connecting an audio source to the Analog Input, follow these steps to adjust the input
Trim control.
1. Set the Tr
im control on the power stand to the 0 (zero) position.
2. Connect the audio source to the Analog Inpu
t.
3. Adjust the volume of the audio source to the desired level.
4. While playing the source, increase the Tr
im level until the Signal/Clip indicator glows
gr
een or yellow.
5. If the Si
gnal/Clip indicator glows red, decrease the Trim level so that it glows only green
or y
ellow.
Using a T1 ToneMatch
TM
audio engine and an analog input source
The L1
TM
model II system can operate with both a T1 ToneMatch
TM
audio engine and an ana-
log audio source connected to the power stand. However, keep in mind that the volume level
of
the audio engine and the analog audio source is adjusted independently.
• The power stand Tr
im control only affects the volume level of the analog audio source con-
nected to the An
alog Input. Therefore, the Signal/Clip indicator indicates the status only
of the analog input signal.
• The T1 ToneMatch audio engine has a Tr
im control and signal/clip indicator for each input,
a Volume control for each output channel, and a Master volume control that adjusts the
level of the ToneMatch output sent to the power stand. These controls have no effect on
the signal fed to the Analog Input.
User scenarios
There are many ways to set up and use this system with and without the T1 ToneMatch audio
engine. The following pages show examples of some typical user scenarios. When using the
T1 ToneMatch audio engine, refer to its owner’s guide for more information on setup and
operation.
Single musician
A solo musician might play a single instrument through the L1 model II system (Figure 11).
A solo musician also might play an instrument and use a microphone for vocals (Figure 12 on
page 16).
Figure 11
Single L1 model II system
with keyboard
VeniceOG.book Page 15 Tuesday, January 16, 2007 1:28 PM

Bose L1 Model II Specifications

General

Product color	Black
Bass adjustment	Yes
Recommended usage	Studio
Multi-Room Streaming (MRS) support	No
Speaker type	-
Number of drivers	2
Speaker placement	Stand-mountable
Audio output channels	- channels
RMS rated power	- W
USB 2.0 ports quantity	1
Connectivity technology	Wired
Power source type	AC

Weight and Dimensions

Depth	450 mm
Width	260 mm
Height	381 mm
Weight	11380 g