Bose Panaray 802 User Manual

8 - English
Installation
Mounting the 802
®
Series IV Loudspeaker on a Speaker Stand
The 802 Series IV loudspeaker can be mounted on a speaker stand, such as the Bose
®
SS10 model. The SS10 comes
with thumb screws for attaching the speaker to the adapter on the top of the stand.
Note: Other stands have not been tested and may create a tipping hazard.
Figure 2. Panaray
®
802 Series IV loudspeaker on a Bose SS10 Speaker Stand
Bose SS10
Speaker Stand
Recommended Power Amplifiers
Selecting the proper amplifier size for a given loudspeaker requires analysis of the transducer long-term (or RMS) power
rating, dynamic range of the input-source material (crest factor), desired sound pressure levels, and other factors. As a
general guideline, the following table provides recommended power amplifier ranges for Bose Panaray
®
loudspeakers:
Model Nominal Impedance Required Channels Amp Power Rating
802 Series IV 8 ohms 1 250 – 500 Watts
CAUTION: Failure to follow these guidelines may result in damage to the loudspeaker!
Please refer to the specifications listed on the pro.bose.com website for PowerMatch
®
amplifiers and compare with the
table above to determine which PowerMatch model is best for your particular Panaray loudspeaker system design.
Recommended DSP Settings
The Bose Panaray 802 Series IV loudspeaker requires active equalization for optimal sound quality. The recommended
equalization is contained in the preset libraries of the Bose PowerMatch
®
Configurable Power Amplifiers, ControlSpace
®
engineered sound and loudspeaker processors.

Bose Panaray 802 Specifications

General

Brand	Bose
Model	Panaray 802
Category	Speakers
Language	English