14
Display
The pilot light shows that the shaver is connected to the
mains.
The display shows the operation mode and charging
status of the shaver: During charging, the display shows
the battery capacity symbol increasing by 20% segments
and the charging time remaining (flashing):
First charging (4 h):
The display counts down in 20 min. steps.
Subsequent chargings (1 h):
The display counts down in 5 min. steps.
The battery is fully charged.
Below 10 minutes remaining shaving time, the display
shows the minutes left. The «moving» plug symbol in-
dicates that you should charge your shaver. If there is in-
sufficient battery charge for a cordless shave, either re-
charge the shaver or shave via the low voltage adapter
connected to the mains.
The display changes to this format when the shaver is in
the Clean&Charge.
The SmartLogic inside your shaver automatically monitors
the condition of the batteries as well as the charging/
discharging processes and adapts them to your personal
shaving patterns. For instance, if it is your routine to never
let the batteries run low, the SmartLogic will recognize this,
look for a pause when you are likely to not use the shaver
and completely discharge and then recharge your shaver
to recondition the batteries (every six months at the most,
and only when necessary).
For additional information, press the info key:
press once:
–to display the duration of the last shave
press again:
–to display the key part number for shaver foil and
cutter block
hold for 3 secs:
–to run a display demo
7680
*
*
*
5491391_7680_Korea Seite 14 Montag, 11. November 2002 2:42 14
To Next Page
Loading...
Need help?
General
