Braun 7680 User Manual

19
Technical specifications
• Power consumption:
• 3 W when cleaning
• 7 W when charging
• Power supply: 100 -240 V 2 / 50 or 60 Hz
(automatic adaptation)
• Input voltage: 12 V
Before using Clean&Charge
Only applies for cordless shavers:
For the first charge of the shaver, connect
the low voltage supply cord directly to the shaver, charge
it for 4 hours and shave at least once.
Onl
y then can the shaver be cleaned or recharged in the
Clean&Charge.
If the rechargeable batteries are discharged, select the
combined «clean» + «charge» programme rather than the
«clean» programme alone.
Installing the cartridge
• Press the lift button (12) to open the housing.
• Hold the cartridge down on a flat, stable surface (e.g.
table). Carefully remove the lid from the cartridge. Slide the
cartridge into the base as far as it will go.
• Slowly close the housing by pushing it down until it locks.
Replacing the cartridge
After having pressed the lift button to open the housing,
wait for a few seconds before removing the used cartridge.
Before discarding the used cartridge, make sure to close
the openings using the lid of the new cartridge, since the
used cartridge will contain contaminated cleaning
solution.
Operating your Clean&Charge
• Connect your Clean&Charge with the low voltage supply
cord to the mains electricity supply.
• Open the contact bow (13) by pressing the
release button (14). After shaving, switch the shaver off
and place it upside down into the Clean&Charge (without
having released the shaver foil).
• Select the operation mode by toggling with the mode
selector (15):
•«clean» (about 15 min)
•«clean» + «charge» (about 75 min)
2
1
old
new
new
7680
a
u
t
o
m
a
t
i
c
l
o
c
k
3
2
10
a
u
t
o
m
a
t
i
c
l
o
c
k
3
2
1
0
o
n
/o
ff
c
le
a
n
c
h
a
r
g
e
c
a
r
t
r
i
d
g
e
7680
7
680
5491391_7680_Korea Seite 19 Montag, 11. November 2002 2:42 14

Braun 7680 Specifications

General

Brand	Braun
Model	7680
Category	Electric Shaver
Language	English