16
Keeping your shaver in top shape
Automated cleaning
The Braun Clean&Charge takes care of all cleaning
and lubrication needs of your shaver. Please refer to
section B.
Manual cleaning
For easy cleaning after each shave, switch the shaver
off. Press the release buttons to lift the shaver foil (do
not remove the foil completely). Switch on
the shaver for
approx. 5-10 seconds so that the shaved stubbles can fall
out.
For a thorough cleaning (weekly), remove the shaver foil
and tap it out on a flat surface. Using the brush, clean the
cutter block and the inner area of the pivoting head. About
every four weeks, clean the cutter block with Braun
cleaning agents.
If your skin is very dry and you notice a reduced operation
time of the shaver or if the display shows «oil!», apply a
drop of light machine oil onto the shaver foil.
Replacing the shaving parts
The shaver foil and cutter block are precision parts that,
in time, are subject to wear. Replace your foil and cutter
block every 18 months and get a 25% better shave.*
(Shaver foil and cutter block: part No. 7000)
(* Overall evaluation from Braun users comparing their
shave with new parts and those used for 18 months.)
Accessories
available at your dealer or Braun Service Centres:
•
Shaver foil and cutter block
(part No. 7000)
oil
10
10
7000
Syncro
7000
5491391_7680_Korea Seite 16 Montag, 11. November 2002 2:42 14
To Next Page
Loading...
Need help?
General
