10
Errors and troubleshooting
Error message Situation Solution
When the battery is running
low, the display ashes the
low battery warning symbol;
however, the device can still
work until the battery life has
0% left.
Replace batteries.
If the steady battery icon is
the only symbol shown on
the display, the device cannot
work. The battery should be
replaced immediately.
Replace batteries.
When in human body
temperature mode, this
message displays when the
measured temperature is
lower than 93.2 °F or higher
than 109.4 °F in or when the
room temperature
is outside the operating range
of 59°- 104 °F or 15 °C- 40 °C.
Re-measure the
temperature, carefully
following the
instructions in “How to
use” section.
When in food/bath
temperature mode (non-
medical use), this message
displays when the measured
temperature is lower than 32
°F or higher than 212 °F, or
when the room temperature is
outside the operating range of
59°-104 °F or 15 °C- 40 °C.
Re-measure the
temperature, carefully
following the
instructions in “Food/
bath temperature
mode” section.
Blank display. Thermometer
does not have power.
Please check if the
batteries have been
loaded correctly. Also
check polarity (<+> and
<–>) of batteries.
Contact customer
service if thermometer
still does not function.
System Error - self-check display
ashes continuously and will not
be followed by the ready beep
and the ready symbol.
If error persists.
If error still persists.
Wait 1 minute until the
thermometer turns o
automatically, then turn
on again
.
...rest the thermometer
by removing the batteries
and putting them back in.
...please contact
customer service.
To Next Page
Loading...
Need help?
General
