Braun L917IB User Manual

Page 60
Front Pump Module Parts List
Control Box Assembly and Harness Options
Item Qty. Description Part No.
6A 1 Control Box Assembly (with Standard Quick Disconnect Harness) ✘ See Note Below 900-0903AQD
6B 1 Control Box Assembly (with Armored Quick Disconnect Harness) ✘ See Note Below 900-0903AQDA
6C 1 Control Box Assembly (with Coiled Quick Disconnect Harness) ✘ See Note Below 900-0903AQDC
6D 1 Control Box Assembly (with 7' Long, 18 Ga., Quick Disconnect Harness) ✘ See Note Below (not shown) 900-5903AQD
7A 1 Harness, Standard, Quick Disconnect (without control box) ✘ See Note Below 900-0902AQD
7B 1 Harness, Armored, Quick Disconnect (without control box) ✘ See Note Below 900-0902AQDA
7C 1 Harness, Coiled, Quick Disconnect (without control box) ✘ See Note Below 900-0902AQDC
7D 1 Harness, 7' Long, 18 Ga., Quick Disconnect (without control box) ✘ See Note Below (not shown) 900-5902AQD
Item Qty. Description Part No. Part No.
1 Pump Module (complete), 12 Volt, Rear 915F4516IBQD-04 915F4516IBQD-04
1 1 Pump Assembly (M268 with Reservoir/with Backup pump) 25597A12V-04 25597A12V-04
2 2 Fitting, 7/16”-20 O-Ring Male / 7/16”-20 JIC 37° Male 24504 24504
3 1 Elbow, 7/16”-20 JIC 37° Female Swivel (1) / 7/16”-20 JIC 37° Male (2) 26579 26579
4 1 Switch, Pressure 26577 26577
5 1 Harness, Pressure Switch / Up - Fold Microswitch 25811A 25811A
61See Control Box Assembly and Harness Options ✘ See note below
71See Control Box Assembly and Harness Options ✘ See note below
8 1 Control Box, Bracket-mount (Items 9, 10 and 11) ✘ See note below 16970A 16970A
9 1 Control Box (only) ✘ See note below 16932 16932
10 1 Clip, Bracket-mount ✘ See note below 16933 16933
11 3 Screw, #6-20 x 1-1/4", Pan Head, Phillips ✘ See note below 16945 16945
12 1 Face Plate and Switch Assembly ✘ See note below 17909A-05 17909A-05
13 1 Face Plate ✘ See note below 16931-05 16931-05
14 1 Switch, S.P.D.T., Rocker (Unfold/Fold) - Orange ✘ See note below 17332 17332
15 1 Switch, S.P.D.T., Rocker (Down/Up) - Red
✘ See note below 16942 16942
16 4 Screw, #6-20 x 3/4", Pan Head, Phillips ✘ See note below 24739 24739
17 1 Strain Relief (SR 7W-2) ✘ See note below (7A, 7B and 7C only) 11352 11352
18 1 Cover, Switch Box 26798 26798
19 1 Plate, Backing / Mounting, Front 915F5501 915F5501
20 1 Harness, Pump Module ✘ See note below 918R3914IBQD 915R3914IBQD
21 4 Snap Rivet, 1/8”, Nylon, Black 25759 25759
22 1 Jumper, Interlock ✘ See note below 15708A 15708A
23 1 Relay, 30 Amp, S.P.D.T., 12 Volt ✘ See note below 18087 18087
24 1 Pop Rivet, SD64BS, 3/16" ✘ See note below 11513 11513
25 1 Washer, #10 Flat 11541 11541
26 2 Washer, 5/16” Flat 10063 10063
27 1 Cable, Ground - 36" ✘ See note below 26161A 26161A
28 4 Bolt, 5/16”-18 x 1/2”, Nylock, Hex (3 shown) * See note below 10012 10012
29 1 Solenoid, Up 10565 10565
30 2 Screw, #10-24 x 1/2”, Button Head, Allen 25842 25842
31 2 Nut, #10-24 with Lock Washer 17388 17388
32 1 Lead Wire Assembly, #6 Gauge Red 915-3506A 915-3506A
33 1 Harness, Solenoid / Microswitch 25810A 25810A
34 1 Cable, Pump Module Power Feed, #2 Gauge Red 26082A 26082A
35 1 Harness, Up Solenoid / Circuit Breaker 25809A 25809A
36 1 Circuit Breaker, 5 Amp, Manual Reset 25736 25736
37 1 Stud, Power Feed 26084 26084
38 1 Cable, Lift Power, 37' with Loom ✘ See note below 205-0712-37 205-0712-37
39 1 Rubber Boot, Red ✘ See note below 82046 82046
L915F, L915FIB L917F, L917FIB
L918F, L918FIB L919F, L919FIB
✘ Indicates items available for replacement part purposes only. These items are not included with replacement pump
modules.
* Apply red #271 Thread Locker Loctite
®
to the three pump mounting bolts (item 28) if a blue nylon patch is not present
on the bolts when retrofitting an M268 pump assembly. Loctite
®
is available from The Braun Corporation under part
number 11522.
L916F, L916FIB

Braun L917IB Specifications

General

Brand	Braun
Model	L917IB
Category	Lifting Systems
Language	English