10
Storage and cleaning
Clean the product with a soft, slightly damp cloth. Stains on the cuff (G) can be
carefully removed with damp cloth. Do not wash or dry clean the cuff. Do not store
the product in a place exposed to direct sunlight or high humidity.
Calibration
This product has been calibrated at the time of manufacture. If used according to
the use instructions, periodic re-calibration is not required.
If at any time, you question the measuring accuracy, please contact a Braun
Service Centre.
Manufacturing date is given by the LOT number on the back of the product.
The first number after LOT represents the last digit of the year of manufacture.
The next three digits give the day of the year of manufacture.
An example: LOT 2116 xx xx – this product has been manufactured on the
116th day of the year 2002.
What to do if ...
Problem Reason Solution
Batteries are low.
Measurements still
possible.
With rechargeable
batteries, the «battery low»
symbol may appear earlier
than with alkaline
batteries.
Battery replacement required soon.
(flashing)
Batteries are flat. Memory
readings can be called up.
Measurements are not
possible.
Insert new batteries.
Cuff is too loose or
cannot be inflated.
Refit cuff tightly, repeat measurement
as shown and described under
«Measuring».
e.g. Error message higher
than 64:
Cuff is not properly fitted.
Refit cuff tightly, repeat measurement
as shown and described under
«Measuring».
6063010_BP2550_S4-58 Seite 10 Dienstag, 8. April 2003 2:17 14
To Next Page
Loading...
Need help?
General
