38
4
5
Assemble Governor
1. Install governor crank from inside cylinder.
Slide washer on crank and install new
push nut or clip.
2. Install governor gear on spindle in sump.
Using thumbs, press firmly until gear clicks
into place.
3. Align dot on timing gear with notch in cam
gear and place cam gear on boss in
cylinder (Inset, Figure 5-1).
4. Slide governor lever on crank and finger-
tighten bolt and nut until crank turns with
slight resistance.
5. Rotate crank so that paddle will be aligned
with cup on governor gear when sump is
installed.
6. Install new sump gasket of same thickness
as originally removed from cylinder.
7. Place seal protector in oil seal and slide
sump over crankshaft until it seats.
8. Install sump screws in order shown (E).
Torque screws to values listed in Section
12 - Engine Specifications.
9. Rotate crankshaft by hand to check for
binding then adjust governor system per
Section 1.
To Next Page
Loading...
Need help?
General
