SEWING BASICS —————————————————————————————————————————————————————————————————————————————————————————————————————
50
Pulling up the bobbin thread
When making gathers, first pull up the bobbin thread as described below.
a
Pass the bobbin thread through the slot.
Do not cut the thread with the cutter.
• Leave the bobbin cover removed.
b
Lightly hold the end of the upper thread.
a Upper thread
c
With the needle raised, press (needle
position button) twice.
a Needle position button
d
Carefully pull the upper thread upward to pull
out the end of the bobbin thread.
a Upper thread
b Bobbin thread
e
Pull out about 10 to 15 cm (4-5 inches) of the
bobbin thread under the presser foot toward
the rear of the machine.
a Upper thread
b Bobbin thread
f
Reattach the bobbin cover.
Insert the tab in the lower-left corner of the
bobbin cover (A), and then press down on the
right side (B).
a
a
b
a
b
AA
B
To Next Page
Loading...
Need help?
General
