APPENDIX ——————————————————————————————————————————————————————————————————————————————————————————————————————————
86
The thread does
not pass through
the eye of the
needle.
The needle was not raised.
Press (needle position button)
once or twice to raise the needle.
page 21
The needle is incorrectly installed. Correctly install the needle. page 29
The stitch is not
sewn correctly.
The presser foot appropriate for the
type of stitch that you wish to sew is
not used.
Attach the presser foot that is
appropriate for the type of stitch that
you wish to sew.
page 79
The thread tension is incorrectly set. Adjust the thread tension. page 47
The thread is tangled, for example, in
the bobbin case.
Remove the tangled thread. If the
thread is tangled in the bobbin case,
clean the race.
page 81
The fabric does
not feed.
The feed dogs are lowered.
Slide the feed dog position switch to
.
page 70
The stitch is too short. Lengthen the stitch length. page 40
The combination of fabric, thread and
needle is incorrect.
Select a thread and needle that are
appropriate for the type of fabric
being sewn.
page 28
The thread is tangled, for example, in
the bobbin case.
Remove the tangled thread. If the
thread is tangled in the bobbin case,
clean the race.
page 81
The sewing lamp
does not come
on.
The sewing lamp is damaged.
Contact your dealer or the nearest
authorized service center.
–
Symptom Probable Cause Remedy Reference
To Next Page
Loading...
Need help?
General
