OKOK
MENUMENU
12
Regular cleaning of your printer will ensure smooth operation of your equipment
Clean the inside of your printer if it is covered with Ink
Use the Clean Stick R dipped in Cleaning Solution to wipe
away the stains on the 3 Carriage Roller Guides.
Move the carriage from side to side to wipe all around the 3
rollers completely.
Clean the Carriage Guide Shaft and the 3 sides [upper, front,
and lower] of the Roller Guide with a non pilling cloth and
moisten with a small amount of isopropyl alcohol [95%]
Do not use alcohol on any other parts except for the carriage
guide shaft and the roller guide.
Apply a small amount of Molykote 30 Grease onto the
Carriage Guide Shaft only. [never on the Roller Guide]
Remove 3 screws to take out the encoder metal cover.
With your non-pilling cloth that is moistened with
alcohol, carefully clean both sides of the Encoder Strip.
Perform a CR Speed Adjustment.
Menu > Printer Setting > CR Speed Adjustment > OK
Print out a Nozzle Check pattern.
Visual inspection is important to keep your printer up and
running. Verify all the moving parts of the machine and also
check for leakage of ink.
Please follow all the instructions that appear on the
printer display.
When you see a yellow number, push the key to review the
warning messages. Complete all tasks as instructed as priority
before continuing to print.
ADDITIONAL WEEKLY MAINTENANCE
INTERNAL CLEANING OF PRINTER
Menu > Maintenance > Maintenance Part Clean/Replace > and follow instructions on the display
Always use this menu to perform cleanings or replace parts:
15
Min
To Next Page
Loading...
Need help?
General
