EasyManuals Logo
Home>BRP>Outboard Motor>Evinrude E15D

BRP Evinrude E15D User Manual

BRP Evinrude E15D
76 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #33 background imageLoading...
Page #33 background image
31
X OPERATION
HIGH ALTITUDE
Your outboard’s EMM will automatically com-
pensate for changes in altitude. However, if
you boat above 3000 ft. (900 m), you will ex-
perience a slight loss of power due to reduced
air density.
If your engine drops below the recommended
RPM operating range at full throttle, have your
Dealer select a lower pitch propeller.
If you return to sea level, have your Dealer in-
stall the original propeller and verify correct
RPM operating range.
FREEZING WEATHER
IMPORTANT: When operating in conditions
under 32°F (0°C), Evinrude/Johnson XD100
oil must be used.
During operation in freezing weather, keep
the gearcase submerged at all times.
Upon removing your outboard from the water,
leave it in a vertical position until its cooling
system is drained. Store the outboard verti-
cally.
If the outboard’s gearcase is equipped with an
integral speedometer pickup, all water must
be cleared from the hose to prevent gearcase
damage. Refer to Storage on page 40.
SHALLOW WATER
Gearcase damage can occur if the gearcase
is allowed to drag on the waterway bottom.
Use caution when operating in shallow water.
IMPORTANT: Impact damage is NOT cov-
ered by the outboard warranty.
DUAL OUTBOARD OPERATION
When in reverse above slow speed, be sure
both outboards are running, even if one is in
NEUTRAL.
If it is necessary to return to harbor with one
outboard not running, tilt the inoperative out-
board high enough to keep its propeller out of
the water.
UNDER TOW
Should you require a tow from another boat:
Shift your engine to NEUTRAL;
Tilt its gearcase out of the water;
Off-load all persons into another boat; and
Keep speed slower than planing speed.
FUSE
Be sure that all active and spare fuses are in
good condition.
Fuse Replacement
IMPORTANT: Use only fuses of the same rat-
ing. Your Evinrude E-TEC outboard uses 10-
amp fuses.
Remove engine cover. Remove the electron-
ics cover.
Detach fuse from plug by pulling down on fuse
connector clip. Install spare fuse in place of
failed fuse.
1. Fuse
2. Spare fuse
IMPORTANT: Failure to install fuse and con-
nector clip securely may cause electrical
problems.
WARNING
Water remaining in the gearcase,
cooling system or other compo-
nents can freeze, causing serious
engine damage.
A blown fuse will not allow the engine to
crank. Replace it with a fuse of the same rat-
ing. A spare fuse is provided.
Repeated fuse failures indicate a potentially
serious problem. Do not replace it with higher
rated fuse; see your Dealer for service.
1
2

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the BRP Evinrude E15D and is the answer not in the manual?

BRP Evinrude E15D Specifications

General IconGeneral
BrandBRP
ModelEvinrude E15D
CategoryOutboard Motor
LanguageEnglish

Related product manuals