51
X INSTALLATION AND ACCESSORIES
IMPORTANT: DO NOT use wing nuts on bat-
tery connections even if they came with the
battery. Wing nuts can loosen and cause er-
rant warning signals or electrical system dam-
age.
Service
Before servicing the battery or the outboard,
remove both battery cables from the battery,
battery negative (–) cable first. Keep metal
objects from contacting either battery post.
IMPORTANT: Service electrical components
only while the outboard is NOT running. Be
careful when identifying positive and negative
battery cables and posts.
ACCESSORY BATTERY
CONNECTION
An optional accessory battery charge kit is
available to allow the charging system to
charge the cranking and accessory batteries
at the same time. See your Dealer to order
and install this kit (P/N 5006253).
IMPORTANT: The accessory battery connec-
tion must only be used to charge a single 12-
volt battery or two 12-volt batteries wired in
parallel. The accessory connection must not
be used to charge either battery in a 24-volt
system.
WATER PRESSURE
An optional water pressure gauge is recom-
mended to monitor cooling system pressures.
Noticing changes in water pressure can help
prevent engine overheating. The water pres-
sure gauge must be connected at the correct
point to ensure the most accurate pressure
readings. Follow the installation instructions
included with the water pressure gauge.
1. Water pressure port (starboard)
WARNING
Battery electrolyte is acidic — han-
dle with care. If electrolyte contacts
any part of the body, immediately
flush with water and seek medical
attention.
Do not use a booster battery and
jumper cables to start the outboard.
Gasoline fumes can cause explo-
sion and fire, resulting in property
damage, personal injury or death.
1
To Next Page
Loading...
Need help?
General
