BRP Evinrude E15D User Manual

39
X MAINTENANCE SCHEDULE
MAINTENANCE SCHEDULE
Routine inspection and maintenance is nec-
essary to prolong outboard life. The following
chart provides guidelines for inspection and
maintenance to be performed by an autho-
rized Dealer.
IMPORTANT: Outboards used in rental, com-
mercial, or other high hour applications re-
quire more frequent inspections and
maintenance. Adjust schedule for operating
and environmental conditions.
Description
Engine
Care
Product
Every 300
Hours or
Three Years
(1)
Electrical and ignition wires, inspect for wear or chafing
3
Engine to transom mounting hardware, re-torque (40 ft. lbs.)
3
Fasteners, inspect any loosened components
3
Fuel and oil system components, inspect and repair leaks
(2)
3
Fuel filter, replace
3
Gearcase lubricant, replace
A
3
Grease fittings, lubricate
(3)
C
3
Power trim/tilt system and fluid level, inspect
B
3
Propeller shaft splines, inspect and lubricate
(3)
C
3
Spark plugs, inspect and replace if necessary
(2)
3
Starter pinion shaft, inspect and lubricate
D
3
Steering system, inspect and lubricate
C
3
Thermostats, inspect
(2)
3
Throttle cable, inspect and re-tension
3
Water pump, inspect or replace if necessary
3
(1) Average recreational use. Commercial use, heavy use, or use in salt or polluted water requires more
frequent inspection and maintenance (annual checks are recommended).
(2) Emission-related component – Refer to Owner Responsibility on page 38, Product Warranty
Information on page 55 and, if applicable, California Emission Control Warranty Statement on
page 58
(3) Annually in salt water applications – Refer to Salt Water Lubrication Points on page 30
A. HPF XR Gearcase Lubricant
HPF Pro Gearcase Lubricant in high performance or commercial applications
B. Power Trim/Tilt and Power Steering Fluid
C. Triple-Guard Grease
D. Starter Bendix Lube ONLY, P/N 337016

BRP Evinrude E15D Specifications

General

Brand	BRP
Model	Evinrude E15D
Category	Outboard Motor
Language	English