Bunn SINGLE SH DBC User Manual

Page 14
PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)
SET NEW RECIPES (cont.)
8. Using (-) and (+), set the amount of brew water,
in ounces, to be dispensed over the grounds for
that particular batch size.
9. When finished, press another batch size and repeat
step #8 for that size. Continue setting all batch
sizes.
10. When finished setting all batch sizes, press and
release DONE. The display should read 3 BATCH
SIZES DONE?
11. If the three batch sizes are not correct, press
and release NO to return to the BREW OUNCES
setup screen and repeat steps 8 through 10. If
the three batch sizes are correct, press YES. This
will advance to the % BYPASS function. (Refer to
page 20 for description of % BYPASS function.)
12. Using (-) and (+) set the amount of bypass water
(percentage) to be dispensed around the grounds
for that particular batch size.
13. When finished, press another batch size and repeat
step #12 for each batch to be set.
14. When finished setting each batch size, press
DONE. The display should read 3 BATCHES
DONE?
15. If the three batch sizes are not correct, press and
release NO to return to the % BYPASS setup screen
and repeat steps 12 through 15. If they are cor-
rect, press YES. This will advance to SET PULSE
BREW. (Refer to page 21 for description of SET
PULSE BREW function.
16. To SET PULSE BREW, if setting pulse brew BY
EXAMPLE (brewing into a funnel) press YES and
proceed with the setup instructions for SETTING
PULSE BREW - BY EXAMPLE, on page 23.
% BYPASS XX.X
(-) DONE (+)
3 BATCHES DONE?
NO YES
SET PULSE BREW?
NO YES
17. If setting pulse brew by ENTER TIMES (entering
known times) press NO. The display should read
ENTER TIMES. Press and release YES and proceed
with the setup instructions for SETTING PULSE
BREW - ENTER TIMES, page 24. After SET PULSE
BREW has been accomplished, the next function
will be SET PREINFUSION. (Refer to page 25 for
description of SET PREINFUSION function.
ON TIME X:XX
(-) DONE (+)
OFF TIME X:XX
(-) DONE (+)
ON OFF
X:XX X:XX
DRIP TIME X:XX
(-) DONE (+)
3 BATCHES DONE?
NO YES
SET PREINFUSION?
NO YES
ADVANCES
TO NEXT
FUNCTION
5 SEC. DELAY
18. To SET PREINFUSION press YES in the SET PRE-
INFUSION screen to proceed. The display should
now read ON TIME and a batch light will be blink-
ing.
19. Using (-) and (+), set the amount of time the brew
water will initially presoak the grounds for that
particular batch size.
20. When finished, press another batch size and repeat
until all three batch sizes are set.
21. When finished, press DONE. The display should
now read OFF TIME and a batch light will be blink-
ing.
P2416
P2417
34025 022509

Bunn SINGLE SH DBC Specifications

General

Brand	Bunn
Model	SINGLE SH DBC
Category	Coffee Maker
Language	English