Page 17
PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)
SET NEW RECIPE:
If not using a Smart Funnel (with a sensor coil) and/
or a G92T DBC Grinder, the brewer will function as
a standard BUNN Single Brewer:
It is possible to operate the brewer without using a
Smart Funnel and/or a G92T DBC Grinder. If a standard
funnel, or if a non-DBC grinder is used the brewer will
automatically select a NO NAME coffee flavor when
the
pad is pressed. This means that no name was
read from the funnel's handle.
There is a NO NAME coffee program that can be
set in the brewer. This includes BREW VOLUMES,
BYPASS PERCENTAGES, PULSE BREW TIMES, PRE-
INFUSION TIMES and DRIP-OUT TIMES. The brewer
will perform in the same capacity as a standard BUNN
Single
TM
Brewer.
The instructions for programming the NO NAME
settings are on the following pages. The same steps
are followed for setting the recipe as those that are
used to MODIFY A RECIPE, beginning on page 19.
Note that when the display reads NO NAME, that
is when MODIFY should be pressed in order to set the
parameters for the NO NAME coffee.
NOTE: Before beginning setup, insert a funnel into
the funnel rails, and place a Soft Heat Server beneath
the brew funnel.
REVIEW RECIPES?
NO YES
(COFFEE NAME)
MODIFYSHOWNEXT
BREW OZ. XX.X
(-) DONE (+)
BREW OZ. XX.X
(-) DONE (+)
NO-NAME
MODIFYSHOWNEXT
EXIT TO
NEXT FUNCTION
SCREEN
P2441
34025 022509
To Next Page
Loading...
Need help?
General
