PROGPROG
PROG
PROG
>3 s
<6 s
>3 s
VA/01 MTMA/01
MTMV/01
beep
Page 3 - Manual FB00877-EN - vers. 1 - 09/2017- © Came S.p.A. - The contents of this manual may be changed, at any time, and without notice.
Press the door-release and AUX2
keys and enter the group call code
(from 1 to 98) followed by key
: The
call code is associated with the internal
receiver and the call key chosen .
Continue, repeating the same opera-
tions for all the other internal receivers.
The operation can only be carried out
from an entry panel with the
LED o.
To change the entry panel from
which to carry out call programming,
you must press key 1 followed by key
.
Programming the call codes
The LED will flash to signal entry into programming C.
With VA/01
Press the PROG key until the PROG LED
lights up .
With MTMA/01-MTMV/01 with-
out VA/01
Press the PROG key for at least 3 sec-
onds and release it within 6 seconds B.
PROGRAMMING CALL CODES AND DOOR-RELEASE CODES
This programming is available only with audio modules MTMA/01 and video modules MTMV/01.
Call programming associates a call code with each internal receiver.
Programming the door-release codes associates number codes with the relays present on audio module MTMA/01 or video
module MTMV/01. The control is local and where there is more than one audio module MTMA/01 and video module MTMV/01
carry out the door-release programming on each entry panel.
Going into Programming
To Next Page
Loading...
Need help?
General
