CAME BPT MTM User Manual

RFID
PROG
+
Ð
M1
A
PROG
󱭇
VA/01 - VA/08
PROG
PROG
󱭈
󱭉
beep
󱭊
beeeep
RFID
PROG
+
Ð
M1
A
PROG
󱭋
VA/01 - VA/08
Page 6 - Manual FB00877-EN - vers. 1 - 09/2017- © Came S.p.A. - The contents of this manual may be changed, at any time, and without notice.
Press key , enter the access code (4
to 8 digits long) followed by key
󱭉.
If the code is valid, the
LED stays
constantly on and it is possible to
continue with programming. Enter the
group call code, or press the call key
associated with the group, followed by
key
󱭊.
A long beep will confirm the procedure
was correct.
 In the event of an error, this will be
indicated by 3 fast beeps. Repeat the
stage correctly.
Put the RFID PROG jumper in the "+"
position. The PROG LED on the power
supply and the
and LEDs will flash
quickly 󱭇 and 󱭈.
When programming is completed, place the RFID PROG jumper as shown in figure
󱭋.
PROGRAMMING ACCESS CONTROL NUMBER CODES
This procedure lets you associate number codes with a group of users, or remove them, for control of door release in audio
module MTMA/01, MTMA/08 and video module MTMV/01, MTMV/08.
A maximum of 5 number codes can be associated per group.
Adding number codes

CAME BPT MTM Specifications

General

Brand	CAME
Model	BPT MTM
Category	Keypad
Language	English