3
• Models That Use a Stand
Assemble the stand on which you will install the printer.
-> Refer to "Assemble the Stand" to "Prepare to Install the Printer" in the Printer Stand Setup Guide (separate manual).
• Models That Do Not Use a Stand
Proceed to "Install the Printer".
1
Remove the packaging material.
2
Remove all of the tape and other packaging material. Open the top
cover (A) and output guide (B), and then remove the tape afxed to
the roll holder.
A
B
3
With 3 people holding the carrying handles under the printer on both ends, lift the printer.
• Moving the printer requires at least 6 people, 3
on either side. Be careful to avoid back strain and
other injuries due to the weight of the printer.
<Printer weight (printer only)>
- PRO-6000 : Approx. 268 lb (122 kg)
- PRO-6000S : Approx. 260 lb (118 kg)
- PRO-4000 : Approx. 231 lb (105 kg)
- PRO-4000S : Approx. 227 lb (103 kg)
- PRO-2000 : Approx. 185 lb (84 kg)
• When moving the printer, rmly grasp the carrying
handles (A) under each side. Holding the printer at
other positions is dangerous and may cause injury
and damage if the printer is dropped.
• When setting the printer down temporarily
,
make
sure to put the printer on a at, stable place.
• When standing the printer up, make sure the side
with the control panel is up, and place cardboard
or other material underneath to prevent scratching.
Furthermore, make sure that the weight of the
printer is taken by the corner of the printer. If the
weight is taken by any other part of the printer, the
printer may become damaged.
• When standing up the printer or supporting the
printer, hold the metal parts of the printer. If
you hold a plastic part, the printer may become
damaged.
• Carrying the printer with only the center of the
printer loaded may cause damage to the printer.
Assemble the Stand
Install the Printer
Caution
A
A
To Next Page
Loading...
Need help?
General