30
Use paper of the same type and size for adjustment as you will use for printing.•
Always make sure the loaded paper matches the type of paper specifi ed in the settings. Adjustment
cannot be completed correctly unless the loaded paper matches the settings.
•
Always check the Adj. Priority values before using Adjust Length .•
(→"Selecting a Feed Amount Adjustment Method (Feed Priority)," User's Guide)
If the Tab Selection screen is not displayed, press the Menu button.•
1
2
To ensure that lines in CAD drawings are printed at exactly the right length, use Adjust Length to adjust the
amount that paper is advanced.
Additionally, two modes are available in both AdjustmentPrint and Change Settings : A:High or B:Standard/
Draft . Choose the mode that suits your particular printing application.
B:Standard/Draft •
A:High •
Items to Prepare
When Using Rolls•
An unused roll at least 10 inches wide
When Using Sheets•
One sheet of unused paper of at least A4/Letter size
Perform adjustment as follows.
Load paper.
On the Tab Selection screen of the Control Panel , press
◄ or ► to select the Settings/Adj. tab (
).
If Line Length Does Not Match
Adjust the length of printed lines as follows.
(→
, Loading Rolls on the Roll Holder)
(→
, Loading Rolls in the Printer)
(→
, Loading Sheets in the Printer)
There are two options in Adjust Length : AdjustmentPrint and Change Settings .
Change Settings •
AdjustmentPrint •
High-precision ruler
High-precision ruler
After a test pattern is printed, you will measure the discrepancy based on the results of printing.
No test pattern is printed. Instead, you will measure a document already printed to determine the discrepancy.
This setting is applied when Highest quality or High is selected in Print Quality in the printer driver.
This setting is applied when Standard or Fast is selected in Print Quality in the printer driver.
678
Tot.Print Area(m2):
Maint.C Remain.: 80%
Ready
OK:Setting/Adj. Menu
To Next Page
Loading...
Need help?
General