40
Error Messages
Error Message Cause Corrective Action
Execute printhead cleaning. The Printhead nozzles are
clogged.
Follow these steps to clean the Printhead .
If the message is still displayed when printing, replace
the Printhead .
Stop printing by pressing ▲ or ▼ to select Stop
Printing .
Clean the Printhead .2.
1.
(→
, If Printing is Faint)
(→ , Replacing the Printhead)
Press ▲ or ▼ to select Print , and then press the OK
button to resume printing. However, note that this
error may affect the printing quality.
If OK is shown on the Display Screen , clean the
Printhead .
If the message is still displayed when printing, replace
the Printhead .
Clean the Printhead .2.
(→
, If Printing is Faint)
(→
, Replacing the Printhead)
Press the OK button on the Control Panel to stop
printing.
1.
Wrong x printhead. (x is L, R, or
not displayed)
An incompatible Printhead has
been installed.
Open the Top Cover . Replace the Printhead L
with a new one if " Printhead L " is displayed and the
Printhead R if " Printhead R " is displayed. If neither
left or right is indicated, replace both Printhead L and
Printhead R with new ones.
(→
, Replacing the Printhead)
x printhead error (x is L, R, or not
displayed)
There is a problem with the
Printhead .
Follow these steps to replace the Printhead .
Open the Top Cover .1.
Replace the Printhead L with a new one if
" Printhead L " is displayed and the Printhead R if
" Printhead R " is displayed. If neither left or right is
indicated, replace both Printhead L and Printhead
R with new ones.
2.
(→ , Replacing the Printhead)
Follow these steps to replace the Printhead .
Turn off the printer, wait a while, and then turn it on
again.
1.
Replace the Printhead L with a new one if
" Printhead L " is displayed and the Printhead R if
" Printhead R " is displayed. If neither left or right is
indicated, replace both Printhead L and Printhead
R with new ones.
2.
(→
, Replacing the Printhead)
PHeads: wrong pos. The printheads are installed in the
wrong positions.
Open the Top Cover and switch the Printhead used
once in the right side to the right side. Switch the
Printhead used once in the left side to the left side.