29
Shooting
The following icons appear on the LCD monitor.
*1 Cannot be set in and modes.
*2 Digital tele-converter cannot be set.
You can combine digital zoom with optical zoom when shooting.
The available shooting characteristics and focal lengths (35mm film
equivalent) are as follows:
[Continuous] [Shoot Only] [Panning]
[Converter] setting
in Rec. menu
Reference
Page
None
p. 113
WC-DC58N/
TC-DC58N/250D
z If you select [Shoot Only] or [Panning] in shooting mode
(still images) and then switch to mode, the setting will
change to [Continuous].
z Camera shake may not be fully corrected when shooting
with slow shutter speeds, such as with evening shots. Use
of a tripod is recommended.
z If camera shake is too strong, it may not be fully corrected.
z Hold the camera horizontally while panning (stabilization
does not work when the camera is held vertically).
Using the Digital Zoom/Digital Tele-Converter
Shooting Mode
Selection Focal Length Shooting Characteristics
Standard 35 – 840 mm
Enables shooting at zoom factors of
up to 24x with digital and optical
zoom combined. In , this setting
is only available in Standard
mode
.
Off 35 – 210 mm
Enables shooting without digital
zoom.
1.5x 52.5 – 315 mm
Digital zoom is fixed at the selected
zoom factor, and the focal length
shifts to maximum telephoto. This
enables a faster shutter speed and
less chance of camera shake than a
shot taken at the same angle of view
with [Standard] or [Off].
1.9x 66.5 – 399 mm
*
1
*
2
To Next Page
Loading...
Need help?
General
Weight and Dimensions
