Pull up the rewind knob until the
back cover pops open.
Too much film slack.
The T50 uses color or black and
white film (negative or slide) in
standard 35 mm cartridges.
Place the cartridge in the film
chamber as shown. Then push
the rewind knob down, turning it
until it drops into its normal posi-
tion.
Pull the film leader across the
camera so that its tip is aligned
with the orange index in the
lower right-hand side of the film
chamber. If the film leader ex-
tends past the orange line,
manually wind the excess film
back into the film cartridge.
Make sure the film perforations
are engaged with the sprocket
teeth, then close the back cover.
Shield the film from direct
sunlight while loading it.
To Next Page
Loading...
Need help?
General
