23
1
Basic Network Settings
This is a connection mode when using a wireless LAN device compatible with Wi-Fi Protected
Setup (WPS). Pushbutton Connection mode (PBC mode) makes it easy to establish a
connection between the camera and the wireless LAN device by pressing the WPS button on
the wireless LAN device.
Note that if multiple wireless LAN devices are active in your area, it may be harder to establish
a connection. In this case, try using [WPS (PIN mode)] to establish a connection.
Confirm the position of the WPS button on the wireless LAN device in advance.
It may take about one minute to establish connection.
1
Select [WPS (PBC mode)].
Turn the <5> dial to select [WPS (PBC mode)],
and then press <0>.
Select [OK] and press <0> to go to the next
screen.
2
Establish a connection with the
wireless LAN device.
Press the WPS button on the wireless LAN device.
For details about where the button is located and
how long to press it, refer to the instruction manual
of the wireless LAN device.
Select [OK] and press <0> to establish a
connection with the wireless LAN device.
When the connection with the wireless LAN device
is established, the [Network] screen (p.25) is
displayed.
WPS Connections (PBC Mode)
To Next Page
Loading...
Need help?
General
