3
39
English
38
English
Attention:
• Not every USB stick is accepted by the Sound L and can be used for the
firmware update. Please use another FAT32 formatted USB memory stick
with the smallest storage capacity available if the update does not start
automatically after connecting the Sound L to the mains.
TECHNICAL DATA
Power supply
• Operating voltage 100–240V~
• Operating frequency 50/60Hz
• Power cons. ECO Standby 0.40W (factroy setting)
• Power consumption NSB Standby 0.53W
• Power consumption AUT Standby ca. 2.6W
• Power consumption MAN Standby ca. 2.6W
• Power cons. in idle mode (no output signal) ca. 6.6W
• Power consumption maximum ca. 150W
Dimensions
• W: 90cm
• H: 7cm
• D: 33cm
Weight
• 11.7kg
Ambient temperature
• Minimum 5°C (41°F)
• Maximum 35°C (95°F)
Decoder
• Dolby Audio
TM
• DTS
®
Digital Surround
TM
• PCM (32kHz-96kHz,
8Bit-24Bit)
Virtualizer
• DTS
®
TruSurround
®
Signal level
• AUX LEFT / AUX RIGHT (Line) = max. 2.0V (effective)
• SUB OUT = max. 2.0V (effective)
Bluetooth® Wireless Technology
• Bluetooth® standard 5.0 (A2DP)
• Distance up to 10m
• Max. transmission power 100mW (+20dBm)
• Frequency range 2402–2480MHz
• Antenna gain 2.0dBi
Wireless Audio
• Max. transmission power 100mW (+20dBm)
• Frequency range 2402–2480 MHz (2412MHz, 2438MHz and 2464MHz)
5180–5240 MHz (5180MHz, 5210MHz and 5240MHz)
5736–5814 MHz (5736MHz, 5762MHz and 5814MHz)
• Antenna gain 4.2dBi @ 2.4GHz, 4.5dBi @ 5GHz
FURTHER IMPORTANT INFORMATION
Information on “Intended Use”
The speaker system is designed for indoor use and must not be used outdoors or
in a wet environment. Do not make any conversions or modifications to the device.
Connect the speaker system as described in the instructions and observe the safety
instructions. Only operate the device with the mains voltage and frequency specified
on the rating plate.
Information about an environmentally friendly operation
To reduce the power consumption, switch the speaker system to standby mode by
pressing the Power
„ “
button when not in use. This “saves power” and lowers your
electricity bill.
Information about the CE marking
Electrical and electronic devices placed on the market within the European
Union must be given a CE mark to indicate that the equipment complies
with the applicable requirements (e.g. equipment safety or electromagnetic
compatibility).
Disposal instructions
According to the EU Directive on Waste Electrical and Electronic Equip-
ment, devices marked with this symbol must not be disposed of together
with municipal waste (household waste). Please inform yourself, if necessary,
contact your local disposal company or the municipal/city administration
about the free disposal for you. It serves the environmental and health
protection as well as the saving of (rare) raw materials by recycling.
Batteries must also not be disposed of together with general household
waste. They must be collected separately and returned to a battery col-
lection point. Throw empty batteries into the collection container free of
charge, for example, those situated at the trade. Improperly disposed of
batteries can harm human and animal health and/or the environment.
To Next Page
Loading...
Need help?
General
