52S
SERIES
SLEEVE INSTALLATION REQUIREMENTS (cont)
ACCESSORY EXTERNAL D_AIN
(OPTIONAL LOCATIONS]
(OO]
AOOE5OORY_ TOP
WALL SLEEVE
(NOTE $2} (
LOUVERED-- )'/
DISCHAR6E GRILLE
C559)
D
_ICE CORD h
3"-_i"
(t067]
2"-7"---
C78_
MINIMUM DISTANCE FROMSLEEVE TO
._ _-0°-2 3/8"
C60)
P
\
I
---- HINGED _NTROL
AOOE_ DOOR
FLOOR LINE
BU] LDING WALLS,SHRUBS,
WALKNAYS ETC*
(597)
(SERVICE CLEARANCE
TO REMOVEUNIT_
0"-0 5/B"
l *J
I CLEAN_kE I
1'-4" _ AIR F1LTER"_I_ \
\\ slo_
(_s_ ==;> \\
SEENOTES$3 z *4 L /e"L_-
T 0"-7 112"-'= 1'-2 ?
(190) C376)
<"-*-_1 "-10 1/4 "*-i--¢
(588)
SIDE l
WALL SLEEVE MOUNTING LOCATION
CNOTE *1
FIGURE 6 -- DIMENSION DRAWING -- 52SC,SE,SQ
STANDARD
. oLrTOOOR
GRILLE
1 "-4 II4"HIN.
(41O]
NOTES FOR FIGURES 6-8
1. Minimum opening sizes apply to all wall openings.
2. Installed wall sleeve must be level from side to side and front to back.
3. Sleeve can be flush mounted to floor, but front panel may have to be
notched to accommodate service cord, except for units with subbase
(see Note 4).
4. 1
When using subbase accessory wall sleeve must extend 3/4-in.
1 1
minimum into room and 3/4 in. minimum to 5/2 in. maximum above
floor.
5. Dimensions in parentheses are in millimeters.
6. For all applications with an accessory lateral duct, sleeve must ex-
tend into the room 1 in. minimum.
7. If wall sleeve extends into room more than 4 in., an accessory sub-
base must be used for support.
8. If wall is less than 2 in. thick, an accessory subbase must be used for
support.
To Next Page
Loading...
Need help?
General
