Cascade J Series User Manual

6871082-R220
PERIODIC MAINTENANCE
1000-Hour Maintenance
Every time the lift truck is serviced or every 1000 hours
of truck operation, complete the following maintenance
procedures:
• Inspect external sideshifter bearings for wear or
damage. If upper bearings are worn to less than
0.06 in. (1.5 mm) thickness, replace bearings. If
lower bearings are worn to less than 0.06 in. (1.5 mm)
exposed thickness, replace bearings.
• Apply general-purpose chassis grease to external
sideshifter upper bearing grease fittings and lower
bearing areas.
• Check lower mounting hooks for engagement clearance
of 0.06 to 0.18 in. (1.5 to 5 mm).
If adjustment is necessary, refer to Installation Step 6.
• Tighten external sideshift cylinder mounting capscrews:
Socket Capscrews (Upper) – 210 ft.-lbs. (285 Nm)
Hex Capscrews (Lower) – 173 ft.-lbs. (235 Nm)
IMPORTANT: If any capscrews are found loose, remove
attachment from truck and check all sideshifter mount
capscrews for proper torque values.
• Tighten lower spacer capscrews. Double-Torque
capscrews by tightening to final torque of 200 ft.-lbs.
(270 Nm), loosen 1/2 turn, then retighten.
In addition to (or in place of, where necessary) the
schedule found in the General Periodic Maintenance
section, perform the following for attachments with
external sideshift:
External Sideshifter
Grease Fittings
External Sideshifter
Lower Bearing
Grease Areas
Lower Hook
Capscrews
External
Sideshifter
Lower Mount
Capscrews
Attachments with External Sideshift
Back (Driver's) View
CC0025.eps
CL6157.eps
CC0026.eps
External Sideshifter
Lower Spacer
Socket Capscrew
Lower Spacer
Capscrews
Hex Capscrew
ATTACHMENTS WITH EXTERNAL SIDESHIFT

Cascade J Series Specifications

General

Brand	Cascade
Model	J Series
Category	Forklifts
Language	English