Cascade J Series User Manual

6871082-R22
GA0380.eps
TRUCK REQUIREMENTS
GA0082.eps
Carriage – Clean carriage bars and
inspect carriage bars. Make sure the
bars are parallel and that ends are
flush. Repair any damaged notches.
Carriage Mount Dimension (A) ITA (ISO)
Minimum Maximum
Class II 14.94 in. (380.0 mm) 15.00 in. (381.0 mm)
WARNING: Rated capacity of the truck/attachment
combination is a responsibility of the original truck
manufacturer and may be less than that shown on the
attachment nameplate. Consult the truck nameplate.
Hoist Up
Auxiliary Valve Functions
Check for compliance with ANSI/ITSDF (ISO) standards:
Tilt Back
Hoist Down
Tilt
Forward
Truck Relief Setting (see attachment nameplate)
Low Pressure High Pressure
2245 psi (155 bar) 2755 psi (190 bar) - Recommended
2740 psi (189 bar) 3625 psi (250 bar) - Maximum
NOTE: The attachment valve has separate pressure
relief control for Clamp and Sideshift functions, see
Installation Step 11 for adjustment.
Truck Flow Volume
➀
8J, 18J Min.
➁
Recommended Max.
➂
SIDESHIFT &
TIPPING
1 GPM
(4 L/min.)
5 GPM
(19 L/min.)
10 GPM
(38 L/min.)
CLAMP
5 GPM
(19 L/min.)
12 GPM
(45 L/min.)
16 GPM
(61 L/min.)
➀ Cascade J-Series Tipping Carton Clamps are compatible with
SAE 10W petroleum base hydraulic fluid meeting Mil. Spec.
MIL-0-5606 or MIL-0-2104B. Use of synthetic or aqueous base
hydraulic fluid is not recommended. If fire resistant hydraulic
fluid is required, special seals must be used. Contact Cascade.
➁ Flow less than recommended will result in reduced system
performance.
➂ Flow greater than maximum can result in excessive heating,
reduced system performance and short hydraulic system life.
TIPPING CARTON CLAMPS
A
GA0028.eps
A
C
B
D
Non-Sideshifting Clamps
A Tip Forward
B Tip Backward
C Release
D Clamp
Sideshifting Clamps
A Sideshift Left
OR
Tip Forward (Push Button)
B Sideshift Right
OR
Tip Backward (Push Button)
C Release
D Clamp

Cascade J Series Specifications

General

Brand	Cascade
Model	J Series
Category	Forklifts
Language	English