Cascade K Series User Manual

1
6055911-R8 EN
FP0695.eps
PERATION
This Section contains operating instructions for the
Cascade K-Series Fork Positioner/Sideshifter. It will help
you avoid common errors which often cause damage to
the equipment or product being handled.
This information is intended to simplify operator
understanding about effective and safe Fork Positioner/
Sideshifter use and operation. Read this information
thoroughly before operating the Attachment. Be sure
you know and understand all operating procedures and
safety precautions. If you have any questions, or don’t
understand a procedure, ask your supervisor.
Emphasize Safety! Most accidents are caused by
operator carelessness or misjudgement. You must
watch for poorly maintained equipment and
hazardous situations and correct them.
NTRODUCTION
I
O
Forks
Backrest
Truck
Carriage
Sideshifter
Fork
Positioner
Special Definitions
The statements shown appear throughout this Manual
where special emphasis is required. Read all WARNINGS
and CAUTIONS before proceeding with any work. State-
ments labeled IMPORTANT and NOTE are provided as
additional information of special significance or to make
the job easier.
CAUTION – A statement preceded by CAUTION is infor-
mation that should be acted upon to prevent
machine damage.
IMPORTANT – A statement preceded by IMPORTANT is
information that possesses special significance.
NOTE – A statement preceded by NOTE is information that
is handy to know and may make the job easier.
WARNING – A statement preceded by
WARNING is information that should be
acted upon to prevent bodily injury. A
WARNING is always inside a ruled box.
This manual is for the Cascade K-Series Integral Fork
Positioner & Sideshifter. Contents include an Operator's
Guide, Installation Instructions, Periodic Maintenance and
Recommended Spare Parts.
IMPORTANT: K-Series Integral Fork Positioner & Side-
shifter is metric. Supply fittings adapted as required for
application.
NOTE: All specifications are shown in Metric units where
applicable. All fasteners have a torque value range of
±10% of stated value.
WARNING: Rated capacity of the truck/
attachment combination is a responsibility
of the original truck manufacturer and may
be less than shown on the attachment
nameplate. Consult the truck nameplate.
WARNING: Do not operate this attachment
unless you are a trained and authorized lift
truck driver.
WARNING: For forks longer than 1520 mm
or load centers exceeding 760 mm, consult
Cascade.
Weighted Emission Sound Pressure Level - Weighted
emission sound pressure level (LpA) does not exceed
70 dB(A).
Measured Value of Whole Body Vibration - Measured
value of whole body vibration (m/s
2
) does not exceed
0,5 m/s
2
.
Measured Value of Hand-Arm Vibration - Measured value
of hand-arm vibration (m/s
2
) does not exceed 2,5 m/s
2
.

Cascade K Series Specifications

General

Brand	Cascade
Model	K Series
Category	Forklifts
Language	English