Cascade K Series User Manual

5
6055911-R8 EN
T
RUCK REQUIREMENTS
GA0131.eps
Auxiliary Valve Functions
Check for compliance with
ISO standards:
A
GA0028.eps
Carriage Mount Dimension (A) ISO
Minimum Maximum
Class II 380.0 mm 381.0 mm
Class III 474.5 mm 476.0 mm
Class IV 595.5 mm 597.0 mm
GA0082.eps
Sideshift
Left
Hoist Up
Tilt
Back
Tilt
Forward
Sideshift
Right
Hoist Down
Carriage – Clean and inspect carriage
bars. Assure that bars are parallel and that
ends are flush. Grind smooth any protruding
welds that may affect sideshifter lower
bearings. Repair any damaged notches.
Open
Forks
Close
Forks
Truck Relief Setting
152 bar Recommended
241 bar Maximum
Truck Flow Volume
➀
Min.
➁
Recommended
Max.
➂
55K, 65K 4 L/min. 7.5 L/min. 12 L/min.
100K, 120K,
150K, 165K
4 L/min. 16L/min. 20 L/min.
➀ Cascade K-Series Fork Positioner/Sideshifters are compatible with
SAE 10W petroleum base hydraulic fluid meeting Mil. Spec. MIL-0-
5606 or MIL-0-2104B. Use of synthetic or aqueous base hydraulic
fluid is not recommended. If fire resistant hydraulic fluid is required,
special seals must be used. Contact Cascade.
➁ Flow less than recommended will result in slow fork positioning
speed.
➂ Flow greater than maximum can result in excessive heating,
reduced system performance and short hydraulic system life.
WARNING: Truck control handle and
attachment function activation shown here
conforms to ISO 3691 ANSI/ITSDF B56.1
recommended practices. Failure to follow
these practices may lead to serious bodily
injury or property damage. End user, dealer
and OEMs should review any deviation from
the practices for safe operation.

Cascade K Series Specifications

General

Brand	Cascade
Model	K Series
Category	Forklifts
Language	English