Auto Light
If Auto Light is enabled, display illumination
will turn on automatically whenever the watch
is positioned at an angle of 40 degrees or more
when it is dark.
Important!
●
Auto Light may not operate properly
when the watch is at a horizontal angle
of 15 degrees or greater from
horizontal as shown in the illustration
below.
●
Auto Light may operate unintentionally
and run down the battery if the watch
is blocked from light by your sleeve.
●
Electro-static charge or magnetism
can interfere with proper auto light
operation. If this happens, try lowering
your arm and then angle it towards
your face again.
●
When moving the watch you may note
a slight rattling sound. This is due to
operation of the auto light switch,
which determines the current
orientation of the watch. It does not
indicate malfunction.
Note
●
Auto Light is disabled when any one of
the conditions below exists.
ー
Alarm, timer alert, or other beeper
sounding
Configuring the Auto Light
Setting
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Hold down (A) for about two seconds.
Release the button when the currently
selected Home City name appears on the
display.
3. Press (D) 12 times to display [AUTO].
4. Press (E) to toggle Auto Light between
enable and disable.
[ON]: Illumination turns on when the watch
is angled towards the face.
[OFF]: Illumination does not turn on when
the watch is angled towards the face.
5. Press (A) to exit the setting screen.
Specifying the Illumination
Duration
You can select either 1.5 seconds or three
seconds as the illumination duration.
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Hold down (A) for about two seconds.
Release the button when the currently
selected Home City name appears on the
display.
3. Press (D) 13 times to display [LIGHT].
4. Press (E) to toggle between the two
illumination duration settings.
[1]: 1.5-second illumination
[3]: 3-second illumination
5. Press (A) to exit the setting screen.
Operation Guide 5582
16
To Next Page
Loading...
Need help?
General
