●
Timer Mode
The main hour and minute hands indicate the
current time.
The second hand, and the small hour and
minute hands indicate the current countdown
time.
30
①
Reset
Start/Stop
③
④
②
Battery level indicator
A Timer seconds
B Timer minutes
C Timer hours
D Timer 24-hour hand
The hand points to the A-side for hours 0
through 11, and to the P-side for hours 12
through 23.
Battery level indicator :
Movement synchronized with Timer minutes.
●
Alarm Mode
In this mode, the main hour and minute hands
indicate the current time in your current
location (Home City), while the small hour and
minute hands show the alarm time setting.
30
①
③
②
Enabling/
Disabling the
Alarm
Illumination
Battery level indicator
A Alarm enabled/disabled
B Alarm time
C Alarm 24-hour hand
The hand points to the A-side for a.m.
times, and to the P-side for p.m. times.
Battery level indicator :
Indicates alarm on/off status.
Using the Crown
The watch’s crown is a screw-in (screw lock)
type. To use the crown, you first need to rotate
it towards you (leftwards) to loosen it.
Important!
●
To prevent loss of water resistance
and/or damage due to impact, be sure
to screw the crown in by rotating it
away from you as you push it in.
●
When pushing the crown back in, take
care not to apply too much force.
●
Fast Forward/Fast Reverse
Second click
First click
Normal timekeeping
Crown
After pulling out the crown to the first or second
click, rotating it quickly in succession in either
direction will start a fast forward or fast reverse
operation. While a fast forward operation is in
progress, quickly rotating the crown in
succession again will increase the speed even
further.
●
Stopping Fast Forward/Fast Reverse
Rotate the crown in the direction opposite that
of the ongoing operation or press any button.
Note
●
If you do not perform any operation for
about two minutes after pulling out the
crown, crown operations will
automatically become disabled. If that
happens, push the crown back in and
then pull it out again.
Watch Operation Guide 5719
8