48
OTHER RECORDING FUNCTIONS
1.
In the REC mode, press MENU.
2.
Select the “REC” tab, select “REC Mode”, and
then rock the controller to the right.
3.
Rock the controller up or down to select
(Snapshot Audio), and then click.
• This enters the Snapshot Audio Mode.
4.
Press the shutter
release button to
record the image.
• After the image is
recorded, the camera
enters audio recording
standby, with the image
you just recorded on the
monitor screen.
• You can cancel audio recording standby by pressing
MENU.
Remaining recording time
5.
Press the shutter release button to start audio
recording.
• The operation/flash charge lamp flashes green as re-
cording is performed.
• Even if you have the monitor screen turned off (page
50), the monitor screen turns on while you are adding
audio to a snapshot.
6.
Recording stops after about 30 seconds or
when you press the shutter release button.
To Next Page
Loading...
Need help?
General
