19
Quick Start Basics
5. After setting the date and time, use [4] and [6] to select “Apply” and
then press [SET].
6. Use [8] and [2] to select “Auto” or “Premium Auto” as the auto
recording mode (page 24) and then press [SET].
• After configuring the auto recording mode setting you want here, you can
toggle between “Auto” and “Premium Auto” by pressing [4] or [6].
NOTE
• Each country controls its local time offset and the use of summer time, and so they
are subject to change.
• Removing the battery from the camera too soon after configuring time and date
settings for the first time can cause the settings to be reset to their factory defaults.
Do not remove the battery for at least 24 hours after configuring settings.
Though the camera has built-in memory that can be used to store images and
movies, you probably will want to purchase a commercially available memory card for
greater capacity. The camera does not come with a memory card. Images and
movies recorded while a memory card is loaded are saved to the memory card. When
no memory card is loaded, images and movies are saved to built-in memory.
• For information about memory card capacities, see page 175.
– SD Memory Card
– SDHC Memory Card
Use one of the above types of memory card.
If you make a mistake configuring display language, date, or time settings with the
above procedure, refer to the following pages for information about how to correct
the settings.
– Display language: Page 146
– Date and time: Page 145
Preparing a Memory Card
Supported Memory Cards
To Next Page
Loading...
Need help?
General
Weight and Dimensions
