E-57
*
1
For information about specifying the payment period,
see the “Payment” item under “Configuring Settings”
on page E-16.
*
2
Make sure the payment you specify for PM2 comes after
the payment you specify for PM1.
*
3
This variable is used by other modes. The value that
initially appears may be a value that was input or
calculated in another mode.
*
4
Specify 2 for semiannual compound interest, or 12 for
monthly compound interest.
•Input money paid out as a negative value, using the y
key to input the minus sign.
A Basic AMRT Mode Procedure
Example 1: To calculate the principal balance (BAL) after
payment 28
1. Input the values for 1, 2, 3, 5, 6, 7, 9, and 0
from the Setting Values table (page E-56).
• For this example, use
fc to select 1 “Set:”,
and then press E.
•Press 2 to select “End”.
•Use fc to select 2
“PM1”, input 15, and then
press E.
• Use fc to select 3 “PM2”, input 28, and then press
E.
•Use fc to select 5 “
I”, input 2, and then press
E.
•Use fc to select 6 “PV”, input 100000, and then
press E.
•Use fc to select 7 “PMT”, input –920, and then
press E.
• Use fc to select 9 “P/Y”, input 12, and then press
E.
•Use fc to select 0 “C/Y”, input 12, and then press
E.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
