E-22
x
y
x0: –1 s10
100
ylogx 100
x= 0: y 0
x 0: y = n,
m
2
n
+1
(m, n are integers)
However: –1 s10
100
ylog \x\100
x
'
y
y0: x & 0, –1 s10
100
1/x logy 100
y= 0: x 0
y 0: x = 2n+1,
2
n
+1
m
(m & 0; m, n are integers)
However: –1 s10
100
1/x log \y\100
a
b
/
c
Total of integer, numerator, and denominator must be 10
digits or less (including division marks).
RanInt#(
a, b)
a b;
\
a
\
,
\
b
\
1 s10
10
; b – a 1 s10
10
• Precision is basically the same as that described under “Calculation Range
and Precision”, above.
• x
y
,
x
'
y
,
3
, x!, nPr, nCr type functions require consecutive internal
calculation, which can cause accumulation of errors that occur with each
calculation.
• Error is cumulative and tends to be large in the vicinity of a function’s singular
point and inflection point.
• The range for calculation results that can be displayed in P form when using
Natural Display is \
x\10
6
. Note, however, that internal calculation error
can make it impossible to display some calculation results in P form. It also
can cause calculation results that should be in decimal form to appear in
P form.
Errors
The calculator will display an error message whenever an error occurs for
any reason during a calculation. There are two ways to exit an error message
display: Pressing B or C to display the location of the error, or pressing
to clear the message and calculation.
Displaying the Location of an Error
While an error message is displayed, press B or C to return to the
calculation screen. The cursor will be positioned at the location where
the error occurred, ready for input. Make the necessary corrections to the
calculation and execute it again.
When you input 14 ÷ 0 s 2 = by mistake instead of 14 ÷ 10 s 2 =
14 0 2
C (or B)
B 1
MathMath
MathMath
To Next Page
Loading...
Need help?
General
