E-50
Message Description Required Action
There is not enough memory.
Increase memory capacity and
try again.
There is not enough memory to
perform the operation.
Increase memory capacity and
try again.
A problem occurred while
launching the emulator.
Try re-starting the application.
If you still cannot launch, it
could mean that the emulator is
damaged. Update the emulator
or reinstall it.
A problem occurred during
emulator startup.
Try restarting the application.
If this does not work, it could
mean that the emulator is
damaged. Update the emulator
or reinstall it.
A problem occurred while
launching the manual (***.pdf)
viewer.
Download the viewer from
the site below and reinstall it.
http://get.adobe.com/reader/
otherversions/
A problem occurred during
manual viewer startup.
Download and install a new
viewer from
http://get.adobe.com/reader/
otherversions/.
The following characters
cannot be used in a Key-Log
record name.
:\/?*[]
The Key-Log record name you
are trying to use contains an
illegal character.
The following characters are
not allowed in Key-Log record
names.
:\/?*[]
A system error has occurred.
(1) Shut down all other
applications that you are not
currently using.
(2) Check how much free
space is available on your
computer’s hard disk.
(3) Exit the emulator and
restart it.
If this does not correct the
problem, it could mean that
the emulator file is damage.
Reinstall the emulator.
—
Follow the steps that are
shown on the display and try
again.
The path and/or filename
exceeds the maximum length
allowed by your Windows
operating system.
The number of letters in the
path or file name you specified
exceeds the allowable limit.
Shorten the specified path or
file name.
A problem occurred while
importing <file name>.
Note that import of a file
created on another model is
not supported.
Some problem occurred while
importing the file.
Make sure that the file was
created using a calculator with
the same model name as this
calculator.
A Key-Log file cannot be
created or opened while Key-
Log data is being played back
or recorded.
Stop playback or recording and
try again.
You are trying to create a
new Key-Log file or open an
existing Key-Log file while Key-
Log data is being played back
or recorded on the calculator.
Stop playback or recording and
try again.
To Next Page
Loading...
Need help?
General
